Parameters
Description
interface
command, but only those ports
that have speed set to 1000/full.
default flowcontrol command
The
default flowcontrol
command is used only on Gigabit Ethernet ports and sets the
flow control to auto, which automatically detects the flow control.
The syntax for the
default flowcontrol
command is:
default flowcontrol [port
<portlist>]
The
default flowcontrol
command is executed in the Interface Configuration mode.
The following table describes the parameters for this command.
Parameters
Description
port <portlist>
Specifies the port numbers to default to auto flow
control.
Note: If you omit this parameter, the system uses the port
number you specified in the
interface
command.
default rate-limit command
The
default rate-limit
command restores the rate-limiting value for the specified port
to the default setting.
The syntax for the
default rate-limit
command is:
default rate-limit [port
<portlist>]
The
default rate-limit
command is executed in the Interface Configuration command
mode.
The following table describes the parameters for this command.
Table 12: default rate-limit command parameters
Parameters
Description
port <portlist>
Specifies the port numbers on which to reset rate-limiting to
factory default. Enter the port numbers on which to set rate-
limiting to default.
Note: If you omit this parameter, the system uses the port
number you specified in the interface command.
Enabling rate-limiting
About this task
The percentage or packets per seconds of multicast traffic, broadcast traffic, or both, can be
limited using the CLI.
ACLI Reference for wired networks
158 Avaya WLAN 8100 CLI Reference
August 2013