show qos action <1–65535> [all] [system] [user]
Variable Definitions
Variable
Value
<10-55000>
Specifies the QoS action; range is 10–55000.
name <WORD>
Assigns a name to a QoS action with the designated action
ID. Enter the name for the action; maximum is 16
alphanumeric characters
drop-action<enable | disable
| deferred-pass>
Specifies whether packets are dropped or not:
• enable—drop the traffic flow
• disable—do not drop the traffic flow
• deferred-pass—traffic flow decision deferred to other
installed policies
Default is deferred pass.
Note: If you omit this parameter, the default value applies.
update-dscp <0-63>
Specifies whether DSCP value are updated or left
unchanged; unchanged equals ignore. Enter the 6-bit DSCP
value; range is 0 to 63.
Default is ignore.
update-1p<0-7>
Specifies whether 802.1p priority value are updated or left
unchanged; unchanged equals ignore:
• ieee1p—enter the value you want; range is 0 to 7
• use-egress—uses the egress map to assign value
• use-tos-prec—uses the type of service precedence to
assign value.
Default is ignore.
Note: Requires specification of
update-dscp
value.
set-drop-prec <low-drop |
high-drop>
Specifies the drop precedence value:
• low-drop
• high-drop
Default is low-drop.
action-ext <1-55000>
Specifies the action extension; range is 1–55000.
action-ext-name <WORD>
Specifies a label for the action extension; maximum is 16
alphanumeric characters.
Removing QoS actions
About this task
Use the following procedure to delete QoS action entries.
ACLI Reference for wired networks
334 Avaya WLAN 8100 CLI Reference
August 2013