Field
Description
hearing an IGMPv1 membership report, this value
is reset to the group membership timer.
When the time remaining is nonzero, the local
interface ignores IGMPv2 leave messages that it
receives for this group.
Type
Indicates whether the entry is learned dynamically
or is added statically.
Flushing the router table
About this task
Use this procedure to flush the router table.
Procedure
To flush the router table, enter the following from the Global Configuration mode:
ip igmp flush vlan <vid> {grp-member|mrouter}
Variable Definitions
Variable
Value
{grp-member|mrouter}
Flushes the table specified by type.
Configuring IGMP selective channel block
About this task
In certain deployment scenarios it might be required not to allow multicast streaming from
specific group addresses to users connected to certain ports. With the IGMP selective channel
block feature this type of control can be implemented. When configured it will control the IGMP
membership of ports by blocking IGMP reports received from users on that port destined for
the specific group address/addresses. The filter can be configured to block a single multicast
address or range of addresses.
This feature will work regardless of whether the switch is in Layer 2 IGMP snooping mode or
the full IGMP mode (PIM-SM enabled). It will also be applicable for IGMPv1 and v2.
Configuring IGMP selective channel block navigation
About this task
•
on page 304
•
on page 304
•
Applying the IGMP filter profile on interface
on page 304
•
Removing a profile from an interface
on page 304
•
ACLI reference for wired networks
Avaya WLAN 8100 CLI Reference
August 2013 303