Avaya WLAN 8100 Series, Reference, Page: 153 / 382

Parameters Description
• 10—10Mb/s
• 100— 100 Mb/s
• 1000— 1000 Mb/s or 1GB/s
• auto— autonegotiation
Note: Enabling and disabling autonegotiation for speed also enables and disables it for duplex
operation.When you set the port speed for autonegotiation, ensure that the other side of the
link is also set for autonegotiation.
default speed command
The
default speed
command sets the speed of the port to the factory default speed.
The syntax for the
default speed
command is:
default speed [port <portlist>]
The
default speed
command is executed in the Interface Configuration command mode.
The following table describes the parameters for this command.
Parameters Description
port <portlist> Specifies the port numbers to set the speed to factory
default. Enter the port numbers you want to set.
Note: If you omit this parameter, the system uses the
port number you specified in the interface
command.
duplex command
The
duplex
command specifies the duplex operation for a port.
The syntax for the
duplex
command is:
duplex [port <portlist>] {full | half
| auto}
The
duplex
command is executed in the Interface Configuration command mode.
The following table describes the parameters for this command.
Parameters Description
port <portlist> Specifies the port numbers for which to reset the
duplex mode to factory default values. Enter the port
number you want to configure. The default value is
autonegotiation.
Note: If you omit this parameter, the system uses the
ports you specified in the interface command.
full | half | auto Sets duplex to:
ACLI reference for wired networks
Avaya WLAN 8100 CLI Reference August 2013 153