Avaya WLAN 8100 Series, Reference, Page: 159 / 382

See the following commands for more information.
Related topics:
show rate-limit command on page 159
rate-limit command on page 159
no rate-limit command on page 159
show rate-limit command
The
show rate-limit
command displays the rate-limiting settings and statistics.
The syntax for the
show rate-limit
command is:
show rate-limit
The
show rate-limit
command is executed in the Privileged EXEC command mode.
rate-limit command
The
rate-limit
command configures rate-limiting on the port.
The syntax for the
rate-limit
command is:
rate-limit {multicast | broadcast
| both} {percent <0-10>}
The
rate-limit
command is executed in the Interface Configuration command mode.
The following table describes the parameters for this command.
Table 13: rate-limit command parameters
Parameters Description
multicast | broadcast | both Applies rate-limiting to the type of traffic.
• multicast--applies rate-limiting to multicast
packets
• broadcast--applies rate-limiting to
broadcast packets
• both--applies rate-limiting to both multicast
and broadcast packets
percent <0-10> Specifies the mode for setting the rates of the
incoming traffic.
• percent <0-10>--enter and integer from 1
to 10 to set the rate-limiting percentage.
For 10 Gb/s links, the default value for
limiting both broadcast and multicast is 10
percent.
Rate limiting using packet per seconds can
only be configured using CLI.
no rate-limit command
The
no rate-limit
command disables rate-limiting on the port.
ACLI reference for wired networks
Avaya WLAN 8100 CLI Reference August 2013 159