Avaya WLAN 8100 Series, Reference, Page: 152 / 382

3. Use the command
edm help-file-path <help-file-path>
to set the EDM
help file path.
Configuring the HTTP Port
About this task
Use the following procedure to configure the HTTP Port.
Procedure
1. Enter Privileged mode of the CLI.
2. Enter Configuration mode by entering the config command.
3. Use the command
http-port <1024–65535>
to set the HTTP port.
Setting port speed
See the following sections for CLI commands to configure port speed and duplexing.
Related topics:
speed command on page 152
default speed command on page 153
duplex command on page 153
default duplex command on page 154
speed command
The
speed
command sets the speed of the port.
The syntax for the speed command is:
speed [port <portlist>] {10 | 100 | 1000
| auto}
The
speed
command is executed in the Interface Configuration command mode.
The following table describes the parameters for the
speed
command.
Table 9: speed command parameters
Parameters Description
port <portlist> Specifies the port numbers for which to
configure the speed. Enter the port numbers
you want to configure.
Note: If you omit this parameter, the system
uses the port number you specified in the
interface command.
10|100|1000|auto Sets speed to:
ACLI Reference for wired networks
152 Avaya WLAN 8100 CLI Reference August 2013
Comments? infodev@avaya.com