Autodesk AUTOCAD 2006, Command Reference Manual, Page: 575 / 1490

Specify opposite corner: Specify a point
Specify rotation angle <0>:
XYZ
Sets X, Y, and Z scale factors.
Specify X scale factor or [Corner] <1>: Specify a nonzero value, enter c , or press
ENTER
■
X Scale Factor: Defines X, Y, and Z scale factors for the block or drawing.
Specify Y scale factor or <use X scale factor>: Enter a scale factor or press
ENTER
Enter Z scale factor <use X scale factor>: Enter a scale factor or press ENTER
Specify rotation angle <0>: Specify an angle or press ENTER
■
Corner: Defines the X and Y scales at the same time, using the insertion
point and another point as the corners of a box, and then defines the Z
scale.
Specify opposite corner: Specify a point
Enter Z scale factor <use X scale factor>: Enter a scale factor or press ENTER
Specify rotation angle <0>: Specify an angle or press ENTER
Basepoint
Temporarily drops the block in the drawing where it is currently positioned
and allows you to specify a new base point for the block reference as it is
dragged into position. This does not affect the actual base point defined for
the block reference.
Specify base point: Specify a base point for the block reference
Scale
Sets the scale factor for the X, Y, and Z axes. The scale for the Z axis is the
absolute value of the specified scale factor.
Specify scale factor for XYZ axes: Enter a nonzero value
Specify insertion point:
Specify rotation angle <0>:
X
Sets the X scale factor.
Specify X scale factor: Enter a nonzero value
Specify insertion point:
Specify rotation angle <0>:
INSERT Command Line | 551