Autodesk AUTOCAD 2006, Command Reference Manual, Page: 40 / 1490

Enter number of longitudinal segments for surface of sphere <16>: Enter a value
greater than 1 or press ENTER
Enter number of latitudinal segments for surface of sphere <16>: Enter a value
greater than 1 or press ENTER
diameter
Torus
Creates a toroidal polygon mesh that is parallel to the XY plane of the current
UCS.
Specify center point of torus: Specify a point (1)
Specify radius of torus or [Diameter]: Specify a distance or enter d
torus radius
1
The radius of the torus is measured from its center point to its outside edge,
not to the center of the tube.
Radius
Defines the torus by its radius.
tube radius
torus radius
Specify radius of tube or [Diameter]: Specify a distance or enter d
The radius of the tube of the torus is measured from the center of the tube to
the outside edge of the tube.
16 | Chapter 2