AudioCodes Mediant 500 E-SBC, User Manual

Page: 826 / 920

User's Manual 826 Document #: LTRT-10437
Mediant 500 E-SBC
54.10.6.3 CAS Parameters
The Common Channel Associated (CAS) parameters are described in the table below.
Table 54-50: CAS Parameters
Parameter Description
Web: CAS Transport Type
EMS: CAS Relay Transport Mode
CLI: CAS-transport-type
[CASTransportType]
Determines the ABCD signaling transport type over IP.

[0] CAS Events Only = (Default) Disable CAS relay.

[1] CAS RFC2833 Relay = Enable CAS relay mode using
RFC 2833.
The CAS relay mode can be used with the TDM tunneling
feature to enable tunneling over IP for both voice and CAS
signaling bearers.
[CASAddressingDelimiters] Enables the addition of delimiters to the received address or
received ANI digits string.

[0] = (default) Disable. The address and ANI strings remain
without delimiters.

[1] = Enable. Delimiters such as '*', '#', and 'ST' are added
to the received address or received ANI digits string.
CLI: cas-delimiters-types
[CASDelimitersPaddingUsage]
Defines the digits string delimiter padding usage per trunk.

[0] = (Default) Default address string padding: '*XXX#'
(where XXX is the digit string that begins with '*' and ends
with '#', when using padding).

[1] = Special use of asterisks delimiters: '*XXX*YYY*'
(where XXX is the address, YYY is the source phone
number, and '*' is the only delimiter padding).
Note: For this parameter to take effect, a device reset is
required.
Web: CAS Table per Trunk
EMS: Trunk CAS Table Index
CLI: cas-table-index
[CASTableIndex_x]
Defines the CAS protocol per trunk from a list of CAS
protocols defined by the parameter CASFileName_x.
For example, the below configuration specifies Trunks 0 and 1
to use the E&M Winkstart CAS (E_M_WinkTable.dat) protocol,
and Trunks 2 and 3 to use the E&M Immediate Start CAS
(E_M_ImmediateTable.dat) protocol:
CASFileName_0 = 'E_M_WinkTable.dat'
CASFileName_1 = 'E_M_ImmediateTable.dat'
CASTableIndex_0 = 0
CASTableIndex_1 = 0
CASTableIndex_2 = 1
CASTableIndex_3 = 1
Notes:

You can define CAS tables per B-channel using the
parameter CASChannelIndex.

The x in the ini file parameter name denotes the trunk
number, where 0 is Trunk 1.
Web: Dial Plan
EMS: Dial Plan Name
CLI: cas-dial-plan-name
[CASTrunkDialPlanName_x]
Defines the CAS Dial Plan name per trunk.
The range is up to 11 characters.
For example, the below configures E1_MFCR2 trunk with a
single protocol (Trunk 5):
ProtocolType_5 = 7
CASFileName_0='R2_Korea_CP_ANI.dat'