AudioCodes Mediant 500 E-SBC, User Manual

Page: 819 / 920

User's Manual 54. Configuration Parameters Reference
Version 6.8 819 Mediant 500 E-SBC
54.10.6 PSTN Parameters
This subsection describes the device's PSTN parameters.
54.10.6.1 General Parameters
The general PSTN parameters are described in the table below.
Table 54-48: General PSTN Parameters
Parameter Description
Web: Trunk Name
CLI: name (config-voip >
interface <e1|t1|bri> name
[DigitalPortInfo_x]
Defines an arbitrary name for a trunk (where x denotes the trunk
number for the ini file parameter). This can be used to help you
easily identify the trunk.
The valid value is a string of up to 40 characters. The following
special characters can be used (without the quotes):

" " (space)

"." (period)

"=" (equal sign)

"-" (hyphen)

"_" (underscore)

"#" (pound sign)
By default, the value is undefined.
Web/EMS: Protocol Type
CLI: protocol
[ProtocolType]
Defines the PSTN protocol for all the Trunks. To configure the
protocol type for a specific Trunk, use the
ini file parameter
ProtocolType_x:

[0] NONE

[1] E1 EURO ISDN = ISDN PRI Pan-European (CTR4) protocol

[2] T1 CAS = Common T1 robbed bits protocols including E&M
wink start, E&M immediate start, E&M delay dial/start and loop-
start and ground start.

[3] T1 RAW CAS

[4] T1 TRANSPARENT = Transparent protocol, where no
signaling is provided by the device. Timeslots 1 to 24 of all
trunks are mapped to DSP channels.

[5] E1 TRANSPARENT 31 = Transparent protocol, where no
signaling is provided by the device. Timeslots 1 to 31 of each
trunk are mapped to DSP channels.

[6] E1 TRANSPARENT 30 = Transparent protocol, where no
signaling is provided by the device. Timeslots 1 to 31, excluding
time slot 16 of all trunks are mapped to DSP channels.

[7] E1 MFCR2 = Common E1 MFC/R2 CAS protocols (including
line signaling and compelled register signaling).

[8] E1 CAS = Common E1 CAS protocols (including line
signaling and MF/DTMF address transfer).

[9] E1 RAW CAS

[10] T1 NI2 ISDN = National ISDN 2 PRI protocol

[11] T1 4ESS ISDN = ISDN PRI protocol for the
Lucent™/AT&T™ 4ESS switch.

[12] T1 5ESS 9 ISDN = ISDN PRI protocol for the
Lucent™/AT&T™ 5ESS-9 switch.

[13] T1 5ESS 10 ISDN = ISDN PRI protocol for the