AudioCodes Mediant 500 E-SBC, User Manual

Page: 716 / 920

User's Manual 716 Document #: LTRT-10437
Mediant 500 E-SBC
Parameter Description
[EnableAutoRAITransmitBER] Enables the device to send a remote alarm indication (RAI) when
the bit error rate (BER) is greater than 0.001.

[0] Disable (default)

[1] Enable
54.3.2 SIP Test Call Parameters
The SIP Signaling Test Call parameters are described in the table below.
Table 54-18: SIP Test Call Parameters
Parameter Description
Web: Test Call DTMF
String
CLI:testcall-dtmf-string
[TestCallDtmfString]
Defines the DTMF tone that is played for answered test calls (incoming
and outgoing).
The DTMF string can be up to 15 strings. The default is "3212333". If no
string is defined (empty), DTMF is not played.
Web: Test Call ID
CLI: testcall-id
[TestCallID]
Defines the test call prefix number ( ID ) of the simulated phone on the
device. Incoming calls received with this called prefix number are
identified as test calls.
This can be any string of up to 15 characters. By default, no number is
defined.
Notes:

This parameter is only for testing incoming calls destined to this
prefix number.

This feature is applicable to all applications (Gateway and SBC).
Web: SBC Test ID
CLI: sbc-test-id
[SBCtestID] Defines the SBC test call prefix (ID) for identifying SBC test calls that
traverse the device to register with an external routing entity such as an
IP PBX or proxy server.
This parameter functions together with the TestCallID parameter, which
defines the prefix of the simulated endpoint. Upon receiving an incoming
call with this prefix, the device removes the prefix, enabling it to forward
the test call to the external entity. Upon receiving the call from the
external entity, the device identifies the call as a test call according to its
prefix, defined by the TestCallID, and then sends the call to the
simulated endpoint.
For example, assume SBCTestID is set to 4 and TestCallID to 2. If a call
is received with called destination 4200, the device removes the prefix 4
and routes the call to the IP PBX. When it receives the call from the IP
PBX, it identifies the call as a test call (i.e., prefix 2) and therefore, sends
it to the simulated endpoint.
The valid value can be any string of up to 15 characters. By default, no
number is defined.
Note: This feature is applicable only to the SBC application.
Test Call Table
Web: Test Call Table
CLI: configure system >
test-call > test-call-table
[Test_Call]
Defines the local and remote endpoints to be tested.
[ Test_Call ]
FORMAT Test_Call_Index = Test_Call_EndpointURI,
Test_Call_CalledURI, Test_Call_RouteBy, Test_Call_IPGroupID,
Test_Call_DestAddress, Test_Call_DestTransportType, Test_Call_SRD,
Test_Call_ApplicationType, Test_Call_AutoRegister,
Test_Call_UserName, Test_Call_Password, Test_Call_CallParty,