AudioCodes Mediant 500 E-SBC, User Manual

Page: 494 / 920

User's Manual 494 Document #: LTRT-10437
Mediant 500 E-SBC
Parameter Description
Destination Type
[IP2IPRouting_DestType]
CLI: dst-type
Determines the destination type to which the outgoing SIP
dialog is sent.

[0] IP Group = (Default) The SIP dialog is sent to the IP
Group’s Proxy Set (SERVER-type IP Group) or
registered contact from the database (if USER-type IP
Group).

[1] Dest Address = The SIP dialog is sent to the address
configured in the following fields: 'Destination SRD ID',
'Destination Address', 'Destination Port', and 'Destination
Transport Type'.

[2] Request URI = The SIP dialog is sent to the address
indicated in the incoming Request-URI. If the fields
'Destination Port' and 'Destination Transport Type' are
configured, the incoming Request-URI parameters are
overridden and these fields take precedence.

[3] ENUM = An ENUM query is sent to include the
destination address. If the fields 'Destination Port' and
'Destination Transport Type' are configured, the incoming
Request-URI parameters are overridden and these fields
take precedence.

[4] Hunt Group = Used for call center survivability. For
more information, see ''Call Survivability for Call Centers''
on page
466 .

[5] Dial Plan = The IP destination is determined by a Dial
Plan index of the loaded Dial Plan file. The syntax of the
Dial Plan index in the Dial Plan file is as follows:
<destination / called prefix number>,0,<IP destination>
Note that the second parameter "0" is ignored. An
example of a configured Dial Plan (# 6) in the Dial Plan
file is shown below:
[ PLAN6 ]
200,0,10.33.8.52 ; called prefix 200
is routed to destination 10.33.8.52
201,0,10.33.8.52
300,0,itsp.com ; called prefix 300
is routed to destination itsp.com
Once the Dial Plan is defined, you need to assign it (0 to
7) to the routing rule as the destination in the 'Destination
Address' parameter, where "0" denotes [PLAN1], "1"
denotes [PLAN2], and so on.

[7] LDAP = LDAP-based routing.

[8] Gateway = The device routes the SBC call to the Tel
side (Gateway call) using an IP-to-Tel routing rule in the
Inbound IP Routing table (see Configuring Inbound IP
Routing Table on page
394 ). The IP-to-Tel routing rule
must be configured with the same call matching
characteristics as this SBC IP-to-IP routing rule. This
option is also used for alternative routing of an IP-to-IP
route to the PSTN. In such a case, the IP-to-Tel routing
rule must also be configured with the same call matching
characteristics as this SBC IP-to-IP routing rule.
Destination IP Group ID
[IP2IPRouting_DestIPGroupID]
CLI: dst-ip-group-id
Defines the IP Group ID to where you want to route the call.
The SIP dialog messages are sent to the IP address defined
for the Proxy Set associated with this IP Group. If you select