AudioCodes Mediant 500 E-SBC, User Manual

Page: 745 / 920

User's Manual 54. Configuration Parameters Reference
Version 6.8 745 Mediant 500 E-SBC
Parameter Description
RFC 3261 Timer B or due to the receipt of a 408
(Request Timeout) response and the device has not
received any provisional response for the call
(indicative of an outbound proxy server failure).

The device terminates a call due to the receipt of a 408
(Request Timeout) response and the only provisional
response the device has received for the call is the 100
Trying provisional response (indicative of a home proxy
server failure).
Note: This parameter is applicable only to the Gateway
application.
Web: ReRegister On Connection
Failure
EMS: Re Register On Connection
Failure
CLI: reg-on-conn-failure
[ReRegisterOnConnectionFailure]
Enables the device to perform SIP re-registration upon
TCP/TLS connection failure.

[0] Disable (default)

[1] Enable
Web: Gateway Registration Name
EMS: Name
CLI: gw-registration-name
[GWRegistrationName] Defines the user name that is used in the From and To
headers in SIP REGISTER messages. If no value is specified
(default) for this parameter, the UserName parameter is used
instead.
Notes:

This parameter is applicable only to the Gateway
application.

This parameter is applicable only for single registration per
device (i.e., AuthenticationMode is set to 1). When the
device registers each channel separately (i.e.,
AuthenticationMode is set to 0), the user name is set to the
channel's phone number.
Web/EMS: Registration Mode
CLI: authentication-mode
[AuthenticationMode] Determines the device's registration and authentication
method.

[0] Per Endpoint = Registration and authentication is
performed separately for each B-channel.

[1] Per Gateway = (Default) Single registration and
authentication for the entire device.
Note: This parameter is applicable only to the Gateway
application.
Web: Set Out-Of-Service On
Registration Failure
EMS: Set OOS On Registration Fail
CLI: set-oos-on-reg-failure
[OOSOnRegistrationFail] Enables setting the trunk or entire device (i.e., all endpoints) to
out-of-service if registration fails.

[0] Disable (default)

[1] Enable
If the registration is per endpoint (i.e., AuthenticationMode is
set to 0) or per Account (see Configuring Hunt Group Settings
on page
355 ) and a specific endpoint/Account registration fails
(SIP 4xx or no response), then that endpoint is set to out-of-
service until a success response is received in a subsequent
registration request. When the registration is per the entire
device (i.e., AuthenticationMode is set to 1) and registration
fails, all endpoints are set to out-of-service. If all the Accounts
of a specific Trunk Group fail registration and if the Trunk
Group comprises a complete trunk, then the entire trunk is set
to out-of-service.