AudioCodes Mediant 500 E-SBC, User Manual

Page: 718 / 920

User's Manual 718 Document #: LTRT-10437
Mediant 500 E-SBC
Parameter Description
call.

[2] Start & End Call = CDR report is sent to Syslog at the start and
end of each call.

[3] Connect & End Call = CDR report is sent to Syslog at
connection and at the end of each call.

[4] Start & End & Connect Call = CDR report is sent to Syslog at
the start, at connection, and at the end of each call.
Notes:

For the SBC application, this parameter enables only signaling-
related CDRs. To enable media-related CDRs for SBC calls, use
the MediaCDRReportLevel parameter.

The CDR Syslog message complies with RFC 3164 and is
identified by: Facility = 17 (local1) and Severity = 6 (Informational).

This mechanism is active only when Syslog is enabled (i.e., the
parameter EnableSyslog is set to 1).
Web: Media CDR Report
Level
[MediaCDRReportLevel] Enables media-related CDRs of SBC calls to be sent to a Syslog
server and determines the call stage at which they are sent.

[0] None = (Default) No media-related CDR is sent.

[1] End Media = Sends a CDR only at the end of the call.

[2] Start & End Media = Sends a CDR once the media starts. In
some calls it may only be after the call is established, but in other
calls the media may start at ringback tone. A CDR is also sent
upon termination (end) of the media in the call.

[3] Update & End Media = Sends a CDR when an update occurs
in the media of the call. For example, a call starts and a ringback
tone occurs, a re-INVITE is sent for a fax call and as a result, a
CDR with the MediaReportType field set to "Update" is sent, as
the media was changed from voice to T.38. A CDR is also sent
upon termination (end) of the media in the call.

[4] Start & End & Update Media = Sends a CDR at the start of the
media, upon an update in the media (if occurs), and at the end of
the media.
Note: To enable CDR generation as well as enable signaling-related
CDRs, use the CDRReportLevel parameter.
Web/EMS: Debug Level
CLI: configure
system/logging/debug-level
[GwDebugLevel]
Enables Syslog debug reporting and logging level.

[0] No Debug = (Default) Debug is disabled.

[1] Basic = Sends debug logs of incoming and outgoing SIP
messages.

[5] Detailed = Sends debug logs of incoming and outgoing SIP
message as well as many other logged processes.
Note: When debug reporting is enabled, in order to view Syslog
messages with Wireshark, you need to install AudioCodes Wireshark
plug-in (acsyslog.dll). Once the plug-in is installed, the Syslog
messages are decoded as "AC SYSLOG" and are displayed using
the 'acsyslog' filter instead of the regular 'syslog' filter.