AudioCodes Mediant 500 E-SBC, User Manual

Page: 692 / 920

User's Manual 692 Document #: LTRT-10437
Mediant 500 E-SBC
Parameter Description
Note: This parameter is applicable only when using the Web
Users table, where the default value of the 'Password Age'
parameter in the Web Users table inherits this parameter's
value.
Web: User Inactivity Timer
[UserInactivityTimer]
Defines the duration (in days) for which a user has not logged in
to the Web interface, after which the status of the user becomes
inactive and can no longer access the Web interface. These
users can only log in to the Web interface if their status is
changed (to New or Valid) by a System Administrator or Master
user.
The valid value is 0 to 10000, where 0 means inactive. The
default is 90.
Note: This parameter is applicable only when using the Web
Users table.
Web: Session Timeout
[WebSessionTimeout]
Defines the duration (in minutes) of inactivity of a logged-in user
in the Web interface, after which the the user is automatically
logged off the Web session. In other words, the session expires
when the user has not performed any operations (activities) in
the Web interface for the configured duration.
The valid value is 0-100000, where 0 means no timeout. The
default is 15.
Note: You can also configure the functionality per user in the
Web Users table (see Advanced User Accounts Configuration
on page 57), which overrides this global setting..
Web: Deny Access On Fail Count
[DenyAccessOnFailCount]
Defines the maximum number of failed login attempts, after
which the requesting IP address is blocked.
The valid value range is 0 to 10. The values 0 and 1 mean
immediate block. The default is 3.
Web: Deny Authentication Timer
EMS: WEB Deny Authentication
Timer
[DenyAuthenticationTimer]
Defines the duration (in seconds) for which login to the Web
interface is denied from a specific IP address (for all users)
when the number of failed login attempts has exceeded the
maximum. This maximum is defined by the
DenyAccessOnFailCount parameter. Only after this time expires
can users attempt to login from this same IP address.
The valid value is 0 to 100000, where 0 means that login is not
denied regardless of number of failed login attempts. The
default is 60.
Web: Display Login Information
[DisplayLoginInformation]
Enables display of user's login information on each successful
login attempt.

[0] = Disable (default)

[1] = Enable
[EnableMgmtTwoFactorAuthenti
cation] Enables Web login authentication using a third-party, smart
card.

[0] = Disable (default)

[1] = Enable
When enabled, the device retrieves the Web user’s login
username from the smart card, which is automatically displayed
(read-only) in the Web Login screen; the user is then required to
provide only the login password.
Typically, a TLS connection is established between the smart