AudioCodes Mediant 500 E-SBC, User Manual

Page: 696 / 920

User's Manual 696 Document #: LTRT-10437
Mediant 500 E-SBC
54.1.4 ini File Parameters
The parameters relating to ini-file management are described in the table below.
Table 54-4: ini File Parameters
Parameter Description
[INIPasswordsDisplayType] Defines how passwords are displayed in the ini file.

[0] Disable (default) = Passwords are obscured ("encoded"). The
passwords are displayed in the following syntax: $1$<obscured
password> (e.g., $1$S3p+fno=).

[1] Enable = All passwords are hidden and replaced by an asterisk
(*).
54.1.5 SNMP Parameters
The SNMP parameters are described in the table below.
Table 54-5: SNMP Parameters
Parameter Description
Web: Enable SNMP
CLI: disable
[DisableSNMP]
Enables SNMP.

[0] Enable (default)

[1] Disable = SNMP is disabled and no traps are sent.
CLI: port
[SNMPPort]
Defines the device's local (LAN) UDP port used for SNMP
Get/Set commands.
The range is 100 to 3999. The default port is 161.
Note: For this parameter to take effect, a device reset is
required.
[ChassisPhysicalAlias] Defines the 'alias' name object for the physical entity as
specified by a network manager, and provides a non-volatile
'handle' for the physical entity.
The valid range is a string of up to 255 characters.
[ChassisPhysicalAssetID] Defines the user-assigned asset tracking identifier object for the
device's chassis as specified by an EMS, and provides non-
volatile storage of this information.
The valid range is a string of up to 255 characters.
[ifAlias] Defines the textual name of the interface. The value is equal to
the ifAlias SNMP MIB object.
The valid range is a string of up to 64 characters.
[SendKeepAliveTrap] Enables the device to send NAT keep-alive traps to the port of
the SNMP network management station (e.g., AudioCodes
EMS). This is used for NAT traversal, and allows SNMP
communication with AudioCodes EMS management platform,
located in the WAN, when the device is located behind NAT. It
is needed to keep the NAT pinhole open for the SNMP
messages sent from EMS to the device . The devicesends the
trap periodically - every 9/10 of the time configured by the
NATBindingDefaultTimeout parameter. The trap that is sent is
acKeepAlive. For more information on the SNMP trap, refer to
the
SNMP Reference Guide .

[0] = (Default) Disable