AudioCodes Mediant 500 E-SBC, User Manual

Page: 677 / 920

User's Manual 52. Testing SIP Signaling Calls
Version 6.8 677 Mediant 500 E-SBC
Parameter Description

For REGISTER messages, if option [1] is used, only Server-
type IP Groups can be used.
IP Group ID
CLI: ip-group-id
[Test_Call_IPGroupID]
Defines the IP Group ID to which the test call is sent or from
which it is received.
Notes:

This parameter is applicable only if option [1] is configured for
the 'Route By' parameter.

This IP Group is used for incoming and outgoing calls.
Destination Address
CLI: dst-address
[Test_Call_DestAddress]
Defines the destination host. This can be defined as an IP
address[:port] or DNS name[:port].
Note: This parameter is applicable only if the 'Route By'
parameter is set to [2] (Dest Address).
Destination Transport Type
CLI: dst-transport
[Test_Call_DestTransportType]
Defines the transport type for outgoing calls.

[-1] = Not configured (default)

[0] UDP

[1] TCP

[2] TLS
Note: This parameter is applicable only if the 'Route By'
parameter is set to [2] (Dest Address).
SRD
CLI: srd
[Test_Call_SRD] Defines the SRD for the endpoint.
The default is SRD 0.
Note: This parameter is applicable only if the 'Route By'
parameter is set any option except [1] (IP Group).
Application Type
CLI: application-type
[Test_Call_ApplicationType]
Defines the application type for the endpoint. This, in effect,
associates the IP Group and SRD to a specific SIP interface. For
example, assume two SIP Interfaces are configured in the SIP
Interface table where one is set to "GW & IP2IP" and one to
"SBC" for the 'Application Type'. If this parameter is set ot "SBC",
the device uses the SIP Interface set to "SBC".

[0] GW & IP2IP (default)

[2] SBC
QoE Profile
CLI: qoe-profile
[Test_Call_QOEProfile]
Assigns a QoE Profile to the test call. To configure QoE Profiles,
see ''Configuring Quality of Experience Profiles'' on page
240 .
Bandwidth Profile
CLI: bandwidth-profile
[Test_Call_BWProfile]
Assigns a Bandwidth Profile to the test call. To configure
Bandwidth Profiles, see ''Configuring Bandwidth Profiles'' on page
244 .
Authentication Tab
Note: These parameters are applicable only if the Call Party parameter is set to Caller.
Auto Register
CLI: auto-register
[Test_Call_AutoRegister]
Enables automatic registration of the endpoint. The endpoint can
register to the device itself or to the 'Destination Address' or 'IP
Group ID' parameter settings (see above).

[0] Disable (default)

[1] Enable
Username
CLI: user-name
[Test_Call_UserName]
Defines the authentication username.
By default, no username is defined.