AudioCodes Mediant 500 E-SBC, User Manual

Page: 578 / 920

User's Manual 578 Document #: LTRT-10437
Mediant 500 E-SBC
9. If you want to load additional files, skip this step and continue with the next step. If you
only want to load a .cmp file, click Reset ; the device burns the .cmp file to its
flash memory and then resets. The device uses the existing configuration (ini) and
auxiliary files.
Note: Device reset may take a few minutes (even up to 30 minutes) depending on
cmp file version.
10. To load additional files, use the Next and Back buttons to navigate through
the wizard to the desired file-load wizard page. Alternatively, you can navigate to the
relevant file-load wizard page by clicking the respective file-name buttons listed in the
left pane of the wizard pages.
11. The wizard page for loading an ini file provides you with the following options:
•
Load a new ini file: In the 'Load an ini file...' field, click Browse , and then
navigate to where the ini file is located on your computer. Select the file, and then
click
Load File ; the device loads the ini file.
Note: If you use the wizard to load an ini file, parameters excluded from the ini file are
assigned default values (according to the .cmp file running on the device) and
thereby, overwrite values previously configured for these parameters.
•
Retain the existing configuration (default): Select the 'Use existing
configuration' check box to use the current configuration (and do not select an ini
file).
•
Restore configuration to factory defaults: Clear the 'Use existing configuration'
check box (and do not select an ini file).
Figure 39-8: Software Upgrade Wizard – Load INI File
12. When you have completed loading all the desired files, click Next until the last
wizard page appears (the FINISH button is highlighted in the left pane):