TeleBoss 830 2.11.370 STD User Manual
Page 9
Power Up Sequence
On startup, the TeleBoss goes through the following boot sequence in approximately 55 seconds:
1. The power LED flashes once each second for 30 seconds.
2. The LEDs for Expansion Card 1 go through a 15 second flashing sequence.
3.
All LED’s then go off for approximately 5 seconds.
4. Power, Modem (if installed) and Ethernet LEDs light for 5 seconds, then Modem and Ethernet go off.
5. Power LED will blink once every 5 seconds as a "heartbeat" while the TeleBoss is powered on.
Accessing the TeleBoss
The TeleBoss has two interface options for command and control. There is an intuitive Web Interface that can
be accessed via the Ethernet connection or via an optional wireless modem card. The TeleBoss can also be
access via a Command Line Interface that can be accessed via Telnet, a serial connection or a serial POTS
modem.
Access via a Network Connection
On the CD that arrives with your TeleBoss there is a program called OmniDiscover. It is located in the Utilities
folder on the CD or you can access it via the Asentria website
http://www.asentria.com/docsandsoftware/productManuals.aspx
).
This program will allow you to locate devices with Asentria MAC addresses on your local area network, and
allow you to assign the network settings directly over the network.
Open the OmniDiscover program. It will display all Asentria devices on the LAN. Right clicking on the line for
the unit will display three options:
Setup
,
Telnet
and
Web
.
Setup
Clicking the Setup button opens another window where the IP Address, Subnet Mask, and Gateway (router)
can be configured. Press “OK” and these will be assigned to the unit and displayed in the previous window.
Note
: For Security reasons, this setup function is only available for the first 5 minutes the unit is powered
on. If your TeleBoss has been powered on longer than that, either power cycle the unit to give yourself
another 5 minutes, or use the serial connection as covered in the
Access via a Serial Connection
below.
