Agilent Technologies 622Vu Advisor, User Manual

Page: 26 / 244

b. Start the Console application.
Note: The Console application requires that a default modem is
configured. See Configure Standard Modem on page 24.
c. Close the 622Vu Advisor application and disconnect power from the
622Vu undercradle.
d. Connect power to the 622Vu undercradle and observe Console messages.
Are power-up messages displayed?
Did the "auto-sensing" of the Ethernet connection work? For example,
did you see a "100 MB Link Established" message?
e. If no messages display, or pressing Enter does not display the ">>"
prompt, check the cabling between the undercradle Console connection
and the Serial connector.
Are you using the provided (null-modem) cable?
Are the connectors firmly attached?
Is the power on and is the Power LED on?
6. Gather information about the Agilent Advisor and the 622Vu undercradle.
Agilent
Advisor In the Start menu, select
Agilent Advisor | ATM Analysis | 622Vu Advisor | Config Tool.
Verify if the registry information is correct. The default information
shows:
Agilent Undercradle Address
Advisor in Config file
IP Address 15.21.191.200 15.21.191.201
Subnet Mask 255.0.0.0
622Vu
Undercradle Connect the provided cable between the Console connector on the
undercradle and the Serial port on the Advisor.
In the Start menu, select
Agilent Advisor | ATM Analysis | 622Vu Advisor | Console.
Verify if the IP Address, Subnet Mask, and Gateway addresses are
correct. Do this by typing commands on the console.
COMMAND DEFAULT RESULTS
show ipaddr 15.21.191.201
show mask 255.0.0.0
show gateway gateway: 15.21.191.200
host/network: 15.21.191.200
1: Installation and Configuration
1.5 Troubleshooting
26