Agilent Technologies 622Vu Advisor, User Manual

Page: 197 / 244

General Tab Settings
The General tab looks like this:
Click the different tabs to
define specifications
relating to session
generation or analysis.
Mark to analyze
traffic received over
the same VCC.
Device from which to
transmit the session.
VCC over which to
transmit the session.
Click when you’re through with the definition (including
theTraffic Pattern and Options), to run the session.
If you haven’t already done so, use the area at the top to specify the type of
session (Round-Trip Delay in this case). Then fill in the generation and analysis
specifications, as described below.
Generation Settings
Click the Generation tab and specify the:
•
Device from which to transmit the session traffic.
If you want to configure the device, click the Properties button to the
right of this drop-down list. The device must be configured for end-
station mode (to allow it to transmit data). You might also use this
feature to define the type of framing to use (SONET vs. SDH, etc.), or other
settings appropriate to the type of device you’re using. Refer to the Chapter
4 for instructions to configure the device, as necessary.
•
VPI/VCI over which to transmit the session.
•
Whether to use the same VPI/VCI for analysis. Mark the check box to
analyze session traffic coming in over the same VCC as the one you’re using
to transmit; otherwise (to use a different VCC), unmark the check box.
If you mark this box, QoSMeter disables all fields on the Analysis tab
(described next).
12: Using QoSMeter
12.3 Defining a Round-Trip Delay (RTD) Session
197