Agilent Technologies 622Vu Advisor, User Manual

Page: 193 / 244

•
Click the Add button to add a new VCC.
This opens the window shown to the right:
Fill in the VPI/VCI to specify the channel
over which to transmit background traffic,
and the bandwidth to commit to traffic
sent over that VCC. Specify the
bandwidth as a percent of total available
bandwidth, using either the slider (right)
or one of the three fields shown
(Percentage, Cells/Sec, or Bits/Sec). All numeric values are in decimal
format.
•
Select a VCC and click the Remove button to delete it.
Options
The Options panel has two tabs:
•
The Execution tab applies for all modes of operation.
•
The Analysis tab applies for Analysis mode and Generation and Analysis
mode.
The discussion below is broken down to cover each mode of operation
separately.
Generation (only) Mode Settings
When running in Generation mode,
there is only one tab in the Options
panel:
Use the Execution tab to specify:
•
Whether to transmit the test
continuously, or only a specified
number of times.
The number of times to transmit the test
during the session (applicable if the
Continuous box is not checked).
•
The amount of time from the start of
one test to the start of the next test. If any one test takes longer than the time
specified, the next test starts immediately upon its completion.
12: Using QoSMeter
12.2 Defining a Constant Bit Rate (CBR) Session
193