R3267 Series Spectrum Analyzer Operation Manual (Vol.1)
1.5 System Checkout
1-10
1.5
System Checkout
This section describes the Selftest which must be performed when operating the R3267 Series for the first
time. Follow the procedure below:
1.
Check to see that the POWER switch (on the front panel) and the MAIN
POWER switch (on the rear panel) are turned off.
2.
Connect the power cable provided to the AC power supply connector on the rear
panel.
CAUTION:
To prevent damage, operate the R3267 Series within specified input
voltage and frequency ranges.
Figure 1-7 Connecting the Power Supply Cable
3.
Connect the power cable to the outlet.
4.
Turn on the MAIN POWER switch (on the rear panel).
5.
Turn on the POWER switch (on the front panel).
The R3267 Series performs the Initial test (processing time: approximately 10
seconds). The start-up screen is displayed as shown in Figure 1-8.
NOTE:
1.
There is a possibility that the screen display is different from the one shown in Fig-
ure 1-8, depending on previously saved conditions.
2.
An error message will be displayed when an abnormal condition is detected. Refer
to the list of error messages to solve the problem (Refer to Section A.2).
AC power supply
connector
