R3267 Series Spectrum Analyzer Operation Manual (Vol.1)
2.3.2 Measuring CDMA Wave’s Total Power
2-75
2.3.2
Measuring CDMA Wave’s Total Power
This section describes the method of measuring the total power of CDMA signal.
Measurement conditions: The unit used in this measurement must be usable with CDMA and output a
frequency of 916.25 MHz and a level of +10 dBm.
Use appropriate parameter values to make the measurements shown below.
CAUTION:
The maximum amount of power that can be input to the analyzer is 30 dBm (1 W). When measur-
ing a signal power whose value exceeds this limit, connect an external attenuator so the power can-
not exceed 30 dBm.
Setup
1.
Connect the unit as shown in Figure 2-85.
Figure 2-85 Setup for Measuring the Total Power
Power on
2.
Turn the analyzer and the unit under test power on.
Setting the unit under test
3.
Activate the signal output for the unit under test.
Initialization
This resets the current settings to the factory defaults or user-defined presets.
4.
Press SHIFT and CONFIG(PRESET).
This sets the analyzer to its presets values.
Setting the measurement conditions
This changes the analyzer settings so that the input signal is displayed more clearly.
5.
Press FREQ, 9, 1, 6, ., 2, 5 and MHz.
A center frequency of 916.25 MHz is set.
