R3267 Series Spectrum Analyzer Operation Manual (Vol.1)
2.4.4 Formatting Media
2-143
Figure 2-157 Media Menu
4.
Press Format Floppy.
The dialog box is displayed to prompt you to confirm whether or not to continue
formatting. To continue formatting, select Confirm.
The floppy disk is formatted with the MS-DOS 1.44MB format. The access lamp
is lit while initializing (this takes approx. 1 minute).
CAUTION:
Do not remove the floppy disk while the access indicator is lit, or the
data on the floppy disk may be damaged.
2.4.4.2 Formatting the Memory Card (Option)
The analyzer can be equipped with the memory card drive as option if desired. You can save data to mem-
ory card as well as the floppy disk drive. The memory card drive has two slots, permitting up to two mem-
ory cards to be plugged in (The slots in the memory card drive are located at the upper right of the front
panel).
Memory cards compatible with the analyzer are as follows.
•
Memory cards compliant with the PC card guidelines Ver.4 (of the Japanese Electronic Industry
Development Association (JEIDA)), or memory card PCMCIA at Release 2.0 or later under the US
standards.
•
Types: SRAM, FLASH ATA or PC Card ATA (using Flash ROM)
•
Format: MS-DOS format
CAUTION:
Flash ROM cards which use the 8- or 16-bit bus system cannot be used in the analyzer. Neither
FLASH ATA nor PC Card ATA card can be used in the analyzer.
Use a memory card after verifying that it complies with the standards shown above. For more
information on the memory card, refer to “Cautions on Using the R3267 Series” in Chapter
Caution.
