Abus SECVEST FUAA50 Series, Installer Manual

Page: 203 / 327

Configuration
203
remote control.
Ethernet Line
Fault Delay Time in seconds until the alarm system responds to a fault in the internet connec-
tion.
PSTN Line
Fault Delay
Time in seconds until the alarm system responds to a fault in the telephone connec-
tion.
GSM Line
Fault Delay
(only when wireless mobile mod-
ule is used)
IP Mobile / Mobile Line Fail
Delay
Time in seconds until the alarm system responds to a fault in the wireless mobile
connection.
GSM Omit Digit
(only when wireless mobile mod-
ule is used)
Mobile without outside dial-
ling
Enabled
If activated, the first digit of the saved telephone number in the phone book is not
selected with the rest of the number for a GSM / wireless mobile connection.

If you want to make calls from a telephone of a private branch exchange into the
public telephone network, you must first dial what is known as the exchange ac-
cess code (code for an outside line) before you dial the telephone number.

In this case, the exchange access code must be entered as the first digit in the
phone book on the alarm panel.

This is followed by the actual destination telephone number.

The exchange access code is available from the administrator of the private
branch exchange or in the instructions of the private branch exchange.

It is usually the number "0"; in the UK it is usually the number "9".

Format of the telephone number: "0 0123 4567890".

The alarm panel can therefore also be connected to an analogue extension of a
private branch exchange.

This extension does not necessarily have to be set up for automatic outside line
dialling.
Deactivated
On a private branch exchange, if you are using an extension that is programmed for
automatic outside dialling, or if you are using a regular analogue telephone connec-
tion, select "Deactivated".
The setting "GSM Omit Digit=Activated" and “Mobile Omit Digit=Activated” affects
numbers to dial for:

ARC reporting

Nursing emergency call

Voice dialler
SMS messages are normally sent only via GSM/wireless mobile. The normal desti-
nation numbers are saved in the phone book:

Format of the telephone number: "0123 4567890".

With a private branch exchange, the alarm panel is connected to an analogue ex-
tension without automatic outside line dialling.

If you want to implement SMS dispatch that starts on the analogue connection of
the alarm system, then under

Installer Mode

Communications

SMS

PSTN SMS

Service Centre Tel.

configure the exchange access code before the actual service centre telephone
number.

Format of the telephone number: "0 0123 4567890".