1-8
Figure 1-8
Configure a stack port on Switch A
z
In the
Port Settings
area, select the check box before
GigabitEthernet1/0/1
.
z
Click
Enable
.
2) Configure the slave devices
# On Switch B, configure local ports GigabitEthernet 1/0/2 connecting with switch A, GigabitEthernet
1/0/1 connecting with Switch C, and GigabitEthernet 1/0/3 connecting with Switch D as stack ports.
z
Select
IRF
from the navigation tree of Switch B to enter the page of the
Setup
tab, and then
perform the following configurations, as shown in
Figure 1-9
.
Summary of Contents for 2928 - Baseline Plus Switch PWR
