1-6
Configuration procedure
# Enable PoE on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2, and configure their power supply
priority to
critical
.
z
Select
PoE
>
PoE
from the navigation tree and click the
Setup
tab to perform the following
configurations, as shown in
Figure 1-5
.
Figure 1-5
Configure the PoE ports supplying power to the IP telephones
z
Click to select ports GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 from the chassis front panel.
z
Select
Enable
from the
Power State
drop-down list.
z
Select
Critical
from the
Power Priority
drop-down list.
z
Click
Apply
.
# Enable PoE on GigabitEthernet 1/0/11 and configure the maximum power of the port to 9000
milliwatts.
z
Click the
Setup
tab and perform the following configurations, as shown in
Figure 1-6
.
Summary of Contents for 2928 - Baseline Plus Switch PWR
