1-27
z
Set the
Root Type
field to
Primary
.
z
Click
Apply
.
3) Configure Switch C.
# Configure an MST region. (The procedure here is the same as that of configuring an MST region on
Switch A.)
# Configure MSTP globally.
z
Select
Network > MSTP
from the navigation tree, and then click
Global
to enter the page for
configuring MSTP globally. See
Figure 1-14
.
z
Select
Enable
in the
Enable STP Globally
drop-down list.
z
Select
MSTP
in the
Mode
drop-down list.
z
Select the check box before
Instance
.
z
Set the
Instance ID
field to 3.
z
Set the
Root Type
field to
Primary
.
z
Click
Apply
.
4) Configure Switch D.
# Configure an MST region. (The procedure here is the same as that of configuring an MST region on
Switch A.)
# Configure MSTP globally.
z
Select
Network > MSTP
from the navigation tree, and then click
Global
to enter the page for
configuring MSTP globally, as shown in
Figure 1-15
.
Summary of Contents for 2928 - Baseline Plus Switch PWR
