1-5
Figure 1-4
Configure a default route
Make the following configurations on the page:
z
Type
0.0.0.0
for
Destination IP Address
.
z
Select
0 (0.0.0.0)
from the
Mask
drop-down list.
z
Type
1.1.4.2
for
Next Hop
.
z
Click
Apply
.
# Configure a static route to Switch A and Switch C respectively on Switch B.
z
After you log in to the Web interface of Switch B, select
Network
>
IPv4 Routing
from the
navigation tree and then click the
Create
tab to enter the page shown in
Figure 1-5
.
Summary of Contents for 2928 - Baseline Plus Switch PWR
