1-2
Authorized IP Configuration Example
Authorized IP Configuration Example
Network requirements
In
Figure 1-2
, configure Switch to deny telnet and HTTP requests from Host A , while permit telnet and
HTTP requests from Host B.
Figure 1-2
Network diagram for authorized IP
Configuration procedure
# Create an ACL.
z
Select
QoS
>
ACL IPv4
from the navigation tree and then click the
Create
tab to enter the ACL
configuration page shown in
Figure 1-3
.
Figure 1-3
Create an ACL
Make the following configurations on the page:
z
Type
2001
for
ACL Number
.
z
Click
Apply
.
# Configure an ACL rule to permit Host B.
z
Click the
Basic Setup
tab to enter the page shown in
Figure 1-4
.
Summary of Contents for 2928 - Baseline Plus Switch PWR
