1-3
Figure 1-3
Configure isolated ports for an isolation group
z
Select
Isolate port
for the port type.
z
Select GigabitEthernet 1/0/2, GigabitEthernet 1/0/3, and GigabitEthernet 1/0/4 on the chassis front
panel.
z
Click
Apply
. A configuration progress dialog box appears.
z
After the configuration process is complete, click
Close
in the dialog box.
# View information about the isolation group.
Click
Summary
. The page shown in
Figure 1-4
appears.
Figure 1-4
Information about port isolation group 1
As shown on the page, port isolation group 1 contains these isolated ports: GigabitEthernet 1/0/2,
GigabitEthernet 1/0/3, and GigabitEthernet 1/0/4.
Summary of Contents for 2928 - Baseline Plus Switch PWR
