1-12
Figure 1-8
Configure the RADIUS authentication server
Perform the following configurations, as shown in
Figure 1-8
.
z
Select
Authentication Server
as the server type.
z
Enter
10.110.91.146
as the IP address of the primary authentication server
z
Enter
1812
as the UDP port of the primary authentication server.
z
Select
active
as the primary server status.
z
Click
Apply
.
# Configure the RADIUS accounting server.
Figure 1-9
Configure the RADIUS accounting server
Perform the following configurations, as shown in
Figure 1-9
.
z
Select
Accounting Server
as the server type.
z
Enter
10.110.91.146
as the IP address of the primary accounting server.
z
Enter
1813
as the UDP port of the primary accounting server.
z
Select
active
as the primary server status.
z
Click
Apply
.
# Configure the parameters for communication between the switch and the RADIUS servers.
z
Select the
RADIUS Setup
tab and perform the following configurations, as shown in
Figure 1-10
.
Summary of Contents for 2928 - Baseline Plus Switch PWR
