11
LED Indicator on Circuit Board
11.3 7 SEG-LED Indicator
11-5
11.3.0.1 7 SEG-LED Indicator Status (1-digit indication) of Each Unit at Error Occurrence
YIF01
All Lit
The power has been turned ON.
0
The booting program has started.
1
The system program has started. (Starts up initialization of various kinds.)
2
Starts verifying the existence of other circuit boards. (Verifies the start-up of the booting program.)
3
Starts the system program transmission.
4
Sends the request of the system program start-up.
5
Starts verifying the existence of other circuit boards. (Verifies the start-up of the system program.)
6
Acquires hardware information, etc. of other circuit boards. (Verifies the IO board status, servo IF,
and so on.)
7
Starts the CMOS data transmission.
8
Sends the pre-online request.
9
Waits for CERF communication synchronization.
A
B
Sends the start-up request of on-line system.
C
The on-line system has started. (Starts up the initialization task.)
D
Processes the DX200 setup completion. (Servo ON enabled)
E
Alarm occurs at the DX200 setup.
F
The maintenance system is starting up.
P
Communications interrupted between NCP01 and the programming pendant.
U
Updating system software through network.
YCP02
All Lit
The power has been turned ON.
0
The booting program has started. (ROM/RAM/FP register check)
1
Starts the booting system. (Completes initialization of various kinds.)
2
Completes the preparation for receiving the system program.
3
The system program has been received. (Waits for the request of system change.)
4
The system program has started. (Starts up hardware initialization of various kinds.)
5
Starts the system. (Completes initialization of various kinds.)
6
Starts the CMOS data transmission.
7
Receives the CMOS mapping. (Waits for pre-online)
8
Starts the optional system. (Starts the process of various initialization.)
9
A
B
C
D
Completes the DX200 setup process.
