Alar
m List
Alar
m Nu
mbe
r (4
00
0 to
4
9
99
)
Alarm List-791
7
The twin synchronous ID
number is incorrect.
Software operation error
occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
8
An attempt was made to
execute triple synchronization
when specified Sub-master
for the master was different.
Setting error
(1)Check the following settings.
∙
Match the system number specification of the master between the job
to be started by SYNC.
other
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4530
CONVEYOR
TRACKING ERROR
1
The base axis specification is
other than 1 or 2 for conveyor
characteristic file.
Setting error
(1)Check the following settings.
∙
Set the base axis specification of conveyor characteristic file to either
0, 1, or 2.
other
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
2
No robot axis in the job for
robot axis tracking
Setting error
(1)Check the following settings.
∙
Correct the job setting so that the robot axis tracking is executed in
the job where robot axis exists.
other
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
3
No base axis in the job for
base axis tracking
Setting error
(1)Check the following settings.
∙
Correct the job settings so that the base axis tracking is executed in
the job where base axis exists.
other
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4
The conveyor board number
and conveyor characteristic
file number used are incorrect.
Setting error
(1)Check the following settings.
∙
Check the specification of conveyor condition file number for use.
Alarm
Number
Alarm Name
Sub
Code
Meaning
Cause
Remedy
