Weir Warman 650 M200-MCR-G, Руководство пользователя, Страница: 217 / 287

82 / 89
BA 5010 EN 03.10
10. Maintenance and repair
Observe the instructions in section 3., "Safety instructions", and in section 9, "Faults, causes and remedy"!
10.1 General notes on maintenance
All maintenance and repair work must be done with care and by duly trained and qualified personnel only.
The following applies to all work in item 10.2:
Switch the gear unit and add­on components off.
Secure the drive unit to prevent it from being started up unintentionally.
Attach a warning notice to the start switch!
The periods indicated in table 30 depend on the conditions under which the gear
unit is operated. Only average periods can therefore be stated here. These refer
to:
a daily operating time of 24 h
a duty factor of
100 %
an input­drive speed of 1500 1/min
a maximum oil temperature of
90 °C
(mineral oil only)
100 °C (synthetic oil only)
The operator must ensure that the intervals stated in table 30 are adhered to.
This also applies if the maintenance work is included in the operator’s internal
maintenance schedules.
Table 30: Maintenance and repair work
Measures Periods Remarks
Check oil temperature Daily
Check for unusual gear­unit noise Daily
Check oil level Monthly
Check gear unit for leaks Monthly
Test the water content of the oil Approx. 400 operating hours,at least
once per year see item 10.2.1
Perform the first oil change Approx. 400 operating hours
after start­up see item 10.2.2
Perform subsequent oil changes Every 24 months or
10000 operating hours see item 10.2.2
Clean air filter Every 3 months see item 10.2.3
Clean fan and gear unit Depending on requirements,
at least every 2 years See item 10.2.4
Refill Taconite seals with grease Every 3000 operating hours
or at least every 6 months see item 10.2.5
Refill Tacolab seals with grease Every 3000 operating hours
or at least every 6 months see item 10.2.6
Check hose lines Yearly see item 10.2.10