Weir Warman 650 M200-MCR-G, Руководство пользователя, Страница: 151 / 287

16 / 89
BA 5010 EN 03.10
4. Transport and storage
Observe the instructions in section 3., "Safety instructions"!
4.1 Scope of supply
The products supplied are listed in the despatch papers. Check immediately on receipt to ensure that all
the products listed have actually been delivered. Parts damaged and/or missing parts must be reported
to FLENDER in writing immediately.
If there is any visible damage, the gear unit must not be put into operation.
4.2 Transport
When transporting FLENDER products, use only lifting and handling equipment
of sufficient load­bearing capacity!
Observe the notes regarding load distribution on the packing.
The gear unit is delivered in the fully assembled condition. Additional items are delivered separately
packaged, if applicable.
Different forms of packaging may be used, depending on the size of the unit and method of transport.
Unless otherwise agreed, the packaging complies with the
HPE Packaging Guidelines.
The symbols marked on the packing must be observed at all times. These have the following meanings:
Top Fragile Keep Keep Centre of Use no Attach
dry cool gravity hand hook here
Fig. 2: Transport symbols
Transport of the gear unit must be carried out so as to avoid personal damage
and damage to the gear unit.
If, for example, the free shaft ends are knocked, this may damage the gear unit.
The gear units must be transported with suitable equipment only.
During transport the gear unit should be left without oil filling.
Exception: In the case of gear units with auxiliary drive, the auxiliary gear unit will be
delivered ex works with oil filling.
Use only the eyes provided to attach lifting equipment to the unit.
Handling of the gear unit by attaching it to the piping is not permitted.
The pipework must not be damaged.
Do not use the front threads at the shaft ends to attach slinging equipment for
the transport.
Slinging equipment must be adequate for the weight of the gear unit.