Weir Warman 650 M200-MCR-G, Руководство пользователя, Страница: 210 / 287

75 / 89
BA 5010 EN 03.10
Table 27: Approximate values for required oil quantities in horizontal gear units with labyrinth seals
Type
Oil quantity (approximate value) in litres for size
3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22
H1SH
5.5 - 19 - 36 - 60 - 106 - 155 - 156 - 225 - ‐ ‐ ‐ ‐
H2SH
4.5 7 11 12 21 23 33 34 58 60 120 130 190 200 260 270 ‐ ‐ ‐ ‐
H2PH ‐ - 25 - 45 - 72 - 110 - ‐ - ‐ - ‐ - ‐ ‐ ‐ ‐
Table 28: Approximative values for additional oil quantities for the intermediate flange when adding on
the auxiliary drive to the main gear unit
Type
Additional oil quantity (approximate value) in litres for size
4 5 6 7 8 9 10 11 12
B3.H
T3.H
1 2 2 5 5 5 6 12 12
Type
Additional oil quantity (approximate value) in litres for size
13 14 15 16 17 18 19 20 21 22
B3.H
15 15 20 20 25 25 40 40 60 60
For details regarding the auxiliary gear unit please see the Special operating
instructions.
(The auxiliary gear unit is delivered ex works with oil filling.)
7.2 Start­up
Before start­up, replace the yellow plastic screw plug with the air filter
(see notice on gear unit).
7.2.1 Oil level
The oil level must be monitored by means of the existing oil­level monitoring equipment. To do so, the gear
unit must be shut down.
When the oil is cool, the level should be at the upper mark on the oil dipstick or the middle of oil-sight glass.
When the oil is warm it may slightly exceed these marks.
It must in no case be allowed to fall below the mark. If necessary, top up to the
correct level.
7.2.2 Gear unit with cooling coil or external oil­supply system
The permissible pressure and temperature values specified in the data sheet and/or list
of equipment must not be exceeded.
This is to be checked before the start­up.
• Fully open the stop valves in the coolant in­ and outflow pipes of the cooling system.
• Check that connecting lines are correctly fastened and tight.
For connecting dimensions, refer to the dimensioned drawing of the gear unit. The
required cooling water quantity and the max. permissible inlet temperature are given on
the data sheet and/or the list of equipment.