Weir Warman 650 M200-MCR-G, Руководство пользователя, Страница: 181 / 287

46 / 89
BA 5010 EN 03.10
The components must be pushed smartly onto the shaft up to the position specified in the order­specific
dimensioned drawing.
Fit the coupling with the aid of suitable fitting equipment. The parts must not be
driven on by abrupt force, as this may damage the gear unit (see also item 6.8).
The shaft­sealing rings and running surfaces of the shaft must not be damaged
when pulling in the coupling parts.
When installing the drives, make absolutely certain that the individual
components are accurately aligned in relation to each other. Inadmissibly large
errors in the alignment of the shaft ends to be connected due to angular and/or
axial misalignments result in premature wear and/or material damage.
Insufficiently rigid base frames or sub­structures can also during operation
cause a radial and/or axial misalignment, which cannot be measured when the
unit is at a standstill.
Gear units whose weight requires the use of lifting gear must be attached at the points
shown in section 4, "Transport and storage". If the gear unit is to be transported with
add­on parts, additional attachment points may be required. The position of these
attachment points is shown in the order related dimensioned drawing.
6.3.2.1 Alignment surfaces, alignment thread
Preliminary alignment of the gear units (sizes 3 to 12) in a horizontal direction is done by the surfaces of
the inspection and/or assembly cover.
Aligning surface:
For the exact position of the aligning surfaces please refer to the drawings of the gear­unit documentation.
The alignment surfaces are for aligning the gear unit horizontally, in order to ensure correct running of the
gear unit.
The values punched into the alignment surfaces must always be observed.
1
1
Fig. 40: Alignment surfaces on gear unit up to size 12