ViaSat ArcLight, Руководство пользователя, Страница: 294 / 368

ArcLight Hub User’s Guide
Component Operating Procedures
5-42 1081006 Rev. 001
Field Description
the UC in response to the 10Mhz Clock On/Off command by the M&C
Rx AGC Acks Number of AGC On/Off Acknowledgments received by the M&C from the UC
in response to the AGC On/Off command by the M&C
Rx CFRQ Acks Number of Center Frequency Set Acknowledgments received by the M&C from
the UC in response to the Center Frequency Set command by the M&C
Rx BANDW Number of DVB Data Rate Set Acknowledgments received by the M&C from
the UC in response to the DVB Data Rate Set command by the M&C
Rx DieTmout
Acks Number of UC Reset Timeout Set Acknowledgments received by the M&C from
the UC in response to the UC Reset Timeout Set command by the M&C
Rx SNR Acks Number of SNR Setup Acknowledgments received by the M&C from the UC in
response to the SNR Setup command by the M&C
Rx PLL Acks Number of PLL Set Acknowledgments received by the M&C from the UC in
response to the PLL Set command by the M&C
Rx IF Acks Number of IF Set Acknowledgments received by the M&C from the UC in
response to the IF Set command by the M&C
Rx LED Acks Number of UC Front Panel LED Acknowledgments received by the M&C from
the UC in response to the LED Set command by the M&C
Rx FW Acks Number of Firmware Download message Acknowledgments received by the
M&C from the UC in response to the Firmware Download message by the
M&C
Rx FW Start
Acks
Number of Firmware Download Start message Acknowledgments received by
the M&C from the UC in response to the Firmware Download Start message
by the M&C
Rx FW Data
Acks
Number of Firmware Download Data message Acknowledgments received by
the M&C from the UC in response to the Firmware Download Data message by
the M&C
Rx FW Blk Acks Number of Firmware Download Block message Acknowledgments received by
the M&C from the UC in response to the Firmware Download Block message
by the M&C
Rx FW End
Acks Number of Firmware Download End message Acknowledgments received by
the M&C from the UC in response to the Firmware Download End message by
the M&C
Rx NACKS Number of Negative Acknowledgments received by the M&C from the UC in
response to the messages sent by the M&C. A NACK implies that UC did not
understand a message from the M&C.
Value End of display response
5.10.7.3.2 MCD M&C ‘com2_stats’ Command
This command displays the current status of the chassis power
supplies, fans, and blowers, chassis temperature, and M&C/WAM
communication status. A typical example is shown in Figure 5-27.
Table 5-7 further describes the output of this command.