IN0CO
−
12
FI1066
Z11554
Seal Lock Adhesive
IN
−
4
−
INTRODUCTION
REPAIR INSTRUCTIONS
4
Author:
Date:
1996 LAND CRUISER (RM451U)
REPAIR INSTRUCTIONS
GENERAL INFORMATION
BASIC REPAIR HINT
(a)
Use fender, seat and floor covers to keep the vehicle
clean and prevent damage.
(b)
During disassembly, keep parts in the appropriate order
to facilitate reassembly.
(c)
Installation and removal of battery terminal:
(1)
Before performing electrical work, disconnect the
negative (
−
) terminal cable from the battery.
(2)
If it is necessary to disconnect the battery for in-
spection or repair, first disconnect the negative (
−
)
terminal cable.
(3)
When disconnecting the terminal cable, to prevent
damage to battery terminal, loosen the cable nut
and raise the cable straight up without twisting or
prying it.
(4)
Clean the battery terminals and cable ends with a
clean shop rag. Do not scrape them with a file or oth-
er abrasive objects.
(5)
Install the cable ends to the battery terminals after
loosening the nut, and tighten the nut after installa-
tion. Do not use a hammer to tap the cable ends
onto the terminals.
(6)
Be sure the cover for the positive (+) terminal is
properly in place.
(d)
Check hose and wiring connectors to make sure that they
are connected securely and correctly.
(e)
Non
−
reusable parts
(1)
Always replace cotter pins, gaskets, O
−
rings, oil
seals, etc. with new ones.
(2)
Non
−
reusable parts are indicated in the component
illustrations by the ”
z
” symbol.
(f)
Precoated parts
Precoated parts are bolts, nuts, etc. that are coated with
a seal lock adhesive at the factory.
(1)
If a precoated part is retightened, loosened or
caused to move in any way, it must be recoated with
the specified adhesive.
(2)
When reusing precoated parts, clean off the old
adhesive and dry with compressed air. Then apply
the specified seal lock adhesive to the bolt, nut or
threads.
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.00 - 12/21/2010
