Tieline Genie Distribution, Руководство пользователя, Страница: 45 / 426

45
© Tieline Research Pty. Ltd. 2020
Genie Distribution WNET Manual v3
termination resistors when required. Please note: U interface ISDN terminations do not
require terminating resistors.
How to Configure ISDN G5 Modules
To configure the codec to dial using ISDN for the first time:
1. Ensure that the correct country setting is configured in your codec via Settings > System >
Country .
2. If you are dialing between two Tieline codecs you normally only need to configure an ISDN
dialing program via Connect > ISDN . Click here to adjust settings using the HTML5 Toolbox
Web-GUI.
Other more advanced settings can also be configured:
1. Select Settings > Modules > [Select ISDN Module] to adjust ISDN module settings
specific to your codec site. See Configure ISDN Module Settings for more information. Click
here to adjust settings using the HTML5 Toolbox Web-GUI.
2. ISDN answering can be configured to suit:
·
Hardware available in the codec, i.e. the number of B channels available.
·
Expected dialing behaviors, e.g. if B channels should bond or not, and whether audio
streams need to use
Route tags.
·
The type of call being made, e.g. Tieline (with Tieline Session Data) versus non-Tieline
(sessionless calls).
Adjust answering configuration via Settings > Answering > ISDN Answer Configs > [Select
Config] and see ISDN Answering Configuration for more information, or click here to adjust
settings using the HTML5 Toolbox Web-GUI).
12.1 ISDN Module Settings
ISDN settings in the Module menu will determine how each installed module operates at a
particular site. Other answering-related settings are available in the Answering menu via Settings
> Answering > [Select ISDN Config ].
Configuring ISDN G5 Modules
1. Press the the SETTINGS button, then navigate to Modules and press the button.
Important Note: You can also configure your ISDN module by pressing the HOME
button to return to the Home screen and select Connect > ISDN . Then use the down
navigation button to select Module Configuration and press the button.
2. Navigate to the module you want to configure and press the button. Note: Module 1 is on the
left when looking at the codec rear panel.