Tieline Genie Distribution, Руководство пользователя, Страница: 358 / 426

358 Genie Distribution WNET Manual v3
© Tieline Research Pty. Ltd. 2020
10. The letter F is displayed on the far right side of the Status Bar to confirm the two codecs have
created a Fuse-IP tunnel. Remember Fuse-IP must be enabled on both codecs.
Please note: double-check all settings on both the server and client codecs if the message Started,
dialing server persists after starting Fuse-IP.
11. Select Fuse-IP as the Via interface with which to connect when creating a program using the
front panel codec menus, or the HTML5 Toolbox Web-GUI Program Manager panel .
Important Notes:
·
Data is sent by the codec over the newly created 'tunnel' as soon as Fuse-IP is enabled,
even if a connection has not been configured and dialed. Depending on the number of
interfaces being used, codecs may transmit and receive up to 24MB of data per hour at
each end of the link.
·
The codec remembers the Fuse-IP enabled/disabled state on power up
·
For additional stability it is recommended that a fixed jitter buffer is configured when
streaming using Fuse-IP. The actual jitter buffer depth should account for the difference in
delay between the interfaces and the maximum jitter experienced. To determine the jitter
over each link you can connect and stream audio over each interface separately and look
at the jitter reading displayed on the
Connection Statistics screen.
·
Use a dotted quad IPv4 address when configuring the Fuse-IP Server Address.