Tieline Genie Distribution, Руководство пользователя, Страница: 204 / 426

204 Genie Distribution WNET Manual v3
© Tieline Research Pty. Ltd. 2020
as UDP audio port 9010 by default for the second audio stream connection.
Click to deselect the
Automatic check-box to adjust this setting. A codec
dialing this connection and using the port specified will always be routed to
output 2 on the codec receiving the call.
Click to configure:
· Auto Jitter Adapt and the preferred auto jitter setting using the drop-down arrow for
Buffer priority . It is also possible to configure the Minimum depth and Maximum
depth of jitter over the connection. See Configuring the Jitter Buffer for more details.
· Alternatively, select a Fixed Buffer Level and enter the Jitter Depth , which must
be between 12ms and 5000ms depending on the algorithm you select.
ISDN module answering settings are used if you select ISDN as the connection transport.
For more details see Configuring ISDN Answering.
POTS module answering settings are used if you select POTS as the connection
transport. For more details see
Configuring POTS Answering .
4. Continue through the steps in the wizard to complete configuration in the same way as the first
connection was configured.
Important Notes:
· Session Port 9002 and Remote Audio Port 9010 are used by default for the second
IP connection.
· Session Port 9002 and Remote Audio Port 9020 are used by default for a third IP
connection when configured.
· Routing of inputs to encoders/outputs can be adjusted using the Matrix Editor panel
in the Toolbox HTML5 Web-GUI.
· If you connect to a G3 codec using IP2 you will need to change the session port on the
Genie Distribution codec to 9012 for the second audio stream connection, as this is
used by default on G3 codecs for IP2.
5. Click Save Program to save all program settings, then click Finish to exit the wizard. The
newly created program can be loaded from within the Program Manager panel and
Connections panel . When this program is loaded any codec connecting using IP1 (using
default Tieline IP port settings) will be routed to output 1 on the codec and a codec dialing in
using IP2 will be routed to output 2.