Tieline Genie Distribution, Руководство пользователя, Страница: 375 / 426

375
© Tieline Research Pty. Ltd. 2020
Genie Distribution WNET Manual v3
3. Program Manager panel : Configure stream level rules for each audio stream as you
proceed through the Program Manager panel wizard.
Important Note: A non-WheatNet-IP Tieline codec can be configured to trigger a logic IO
in a Tieline Genie Distribution and Merlin PLUS WheatNet-IP codec, as well as 4 physical
CONTROL PORT GPIOs. The codec has:
· 4 physical CONTROL PORT GPIOs.
· 7 Tieline and WheatNet virtual inputs (1-7). Note: Virtual inputs 5-7 can be activated
by pressing the
F1 button and KEYPAD buttons 1-3.
· 64 Tieline virtual logic outputs. Note: Tieline logic IOs (LIOs) are only supported
between Genie, Merlin, ViA and Bridge-IT IP codecs.
· 64 virtual WheatNet logic outputs available in Genie Distribution and Merlin PLUS
WheatNet-IP codecs. These allow Tieline WheatNet-IP enabled codecs to activate
functions across a WheatNet-IP network.
See the section titled Creating Rules for more information.
Configuring RS232 Data
Once Data is enabled, the codec can be connected to external devices and transport RS232-
compatible data via the serial port on the rear panel of the codec.
1. Press the SETTINGS button.
2. Navigate to System and press .
3. Select RS232 Config and press .
4. Use the navigation buttons to select the correct baud rate.
5. Select Enable for flow control and press to save all settings.
Important Notes:
·
When connecting to G3 codecs over IP, ISDN or POTS only in-band data is available via
the Music and MusicPLUS algorithms. See
RS232 Data Configuration for more details.
·
It is important that you enable serial port flow control within the codec. Flow control
regulates the flow of data through the serial port. If disabled, data will flow unregulated
and some may be lost.
·
Ensure you match the serial port baud rate to match the rate of the external device you
are connecting to. Ideally the settings on both codecs should match, or you could have
data overflow issues.
·
Only the dialing codec needs to be configured to send RS232 data to another Tieline G5
codec. Session data sent from the dialing codec configures the answering codec.
21.13 Monitor Control Port I/O Status
It is possible to monitor the status of the four relay inputs and four opto-isolated outputs available
using the DB15
CONTROL PORT IN / OUT connector. To monitor status:
1. Press the SETTINGS button.
2. Use the navigation buttons to select Control Port I/O and press the button.
3. Select Inputs and then press the button to view input status.