Terex Genie GS-2669 BE, Руководство по обслуживанию

Страница: 75 / 205

May 2015 Service Manual
Scissor Components
Part No. 1257106 GS-2669 BE • GS-3369 BE • GS-4069 BE 59
13 Remove the retaining fasteners from the
number 3 pivot pins.
Note: Do not remove the external snap ring.
14 Using a soft metal drift, remove the pivot pins
and set aside.
15 Carefully lift the linkage assembly off of the
machine and place it on a structure capable of
supporting it.
16 Using an overhead lifting device attach a
4 hook sling chain to the ends of the number
2 inner arm. Make the chains tight but do not
apply lifting pressure.
Crushing hazard. The linkage
assembly could become
unbalanced and fall if not
properly supported when
removed from the machine.
17 Remove the retaining fasteners from the
number 2 pivot pins.
Note: Do not remove the external snap ring.
18 Using a soft metal drift, remove the pivot pins
and set aside.
19 Carefully lift the linkage assembly off of the
machine and place it on a structure capable of
supporting it.
20 Tag and disconnect the harness from the lift
cylinder valve block.
21 Tag and disconnect the hydraulic hoses from
the lift cylinder. Plug the hoses and cap the
fittings.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
22 Remove the hose clamps and hoses from the
number 1 inner arm.
23 Using an overhead lifting device attach a
4 hook sling chain to the ends of the number
1 inner arm. Make the chains tight but do not
apply lifting pressure.
Crushing hazard. The linkage
assembly could become
unbalanced and fall if not
properly supported when
removed from the machine.
24 Remove the two carriage bolts that secure the
inner arm and chassis pivot to the steer end of
the drive chassis.
25 Move the linkage towards the non-steer end of
the machine until the slider feet are clear of
the slider channel.
26 Carefully lift the linkage assembly off of the
machine and place it on a structure capable of
supporting it.