Sterling 360, Руководство по эксплуатации и обслуживанию

Страница: 67 / 213

6-11
8 Check engine indicator/warning
There are two check engine lights: an amber indica-
tor light and a red warning light.
Both check engine lights illuminate as bulb checks
when the ignition key is turned to “ON.” They should
go out when the engine starts.
8.1 Check engine indicator (amber)
The amber check engine indicator illuminates when
there is a malfunction in the electronic control cir-
cuitry of the fuel injection system. If the light illumi-
nates, shut down the engine, and keep the ignition
switch in “ACC” or “LOCK” for 5 seconds or longer,
if necessary, to reset the computer. Then restart the
engine.
If the light stays off, there is no problem. If the light
illuminates again, bring the vehicle to an authorized
Sterling service facility as soon as possible.
8.2 Check engine warning (red)
The red check engine warning illuminates when
there is a serious malfunction in the electronic con-
trol circuitry of the fuel injection system. There may
be a noticeable reduction in engine output. If the
light illuminates, shut down the engine, and keep
the ignition switch in “ACC” or “LOCK” for 5 sec-
onds or longer, if necessary, to reset the computer.
Then restart the engine.
If the light stays off, there is no problem. If the light
illuminates again, shut down the engine and contact
an authorized Sterling service facility.
9 ABS warning
The ABS warning illuminates as a bulb check when
the ignition key is turned to “ON.” It should go out a
few seconds later. If the light comes on again, there
is a malfunction in the antilock braking system
(ABS). Should this light illuminate during driving,
stop the vehicle in a safe place and perform the fol-
lowing inspection procedure.
1. Turn the ignition key to “OFF” and then back to
“ON” again.
2. Determine the state of the system as follows:
•
If the light goes out a few seconds later, the sys-
tem is normal. If the light stays on for more than
a few seconds but goes off when the engine is
started, this is also normal.
•
If the light stays on for longer than a few sec-
onds, or if it goes off but comes on again, or it
remains on after the engine is started, there is a
fault in the system.
3. If a fault is found, have the ABS repaired without
delay by an authorized Sterling service facility.
NOTE:
If there is a fault that causes the ABS warning to
illuminate, the service brakes can still stop the vehi-
cle. However, under certain conditions, brake per-
formance can be reduced. The vehicle can be
driven to a repair facility, provided great care is
taken on slippery surfaces.
Z11795
Z10986