Sterling 360, Руководство по эксплуатации и обслуживанию

Страница: 37 / 213

5-4
Switches and controls
•
LOCK
The ignition key can be inserted and removed
only in the “LOCK” position. To place the key in
“LOCK,” turn it to the “ACC” position, then press
it in, and keep it pressed in while turning it to
“LOCK.” When the key is removed, the steering
wheel locks.
In “LOCK,” the headlight switch, panel light
switch, hazard flashers, interior lights, horn,
master door locks, and turn signals operate.
•
ACC
Use the “ACC” position only when the engine is
shut down.
In “ACC,” the cigarette lighter operates. Audio
equipment (radio, etc.) installed and connected
in the approved manner also operates.
•
ON
Use the “ON” position when the engine is run-
ning.
All electrical circuits operate.
•
START
Use the “START” position for cranking and start-
ing the engine.
Once the engine is running, release the key and
the switch will automatically return to “ON."
NOTE:
•
Do not turn the key until it is fully inserted into
the ignition switch.
•
If you are unable to turn the key, gently turn the
steering wheel back and forth as you turn the
key.
•
To warm up the engine quickly, or to make the
heater work more effectively when the vehicle is
not moving, turn ON the engine warm-up switch
. The exhaust brake begins to operate and the
exhaust brake indicator illuminates.
•
P. 5-10
•
When the exhaust brake operates, the idle
speed of the engine increases and the engine
warms up more quickly.
•
When the engine has finished warming up, the
exhaust brake stops operating. The exhaust
brake indicator turns off.
•
Once the engine has warmed up and/or the
heater is working satisfactorily, turn OFF the
engine warm-up switch.
Engine warm-up switch
Z10782
Z14897