Installation and User Manual
EtherHaul
1200™
Page 46
EH-INST-02, Issue 4.0
Admin Status
– Determines whether the port is enabled (
up
) or disabled
(
down
). Default value is
up
.
Oper. Status
– Displays the operational status of the port -
up
or
down
.
Auto Negotiation
– Determines whether or not auto-negotiation is enabled
(
enabled
) or disabled (
disabled
). Default value is
enabled
.
Ethernet Type
– When Auto Negotiation is disabled, select the port’s speed
manually in this field (10/100/1000, HF/FD). When using the SFP physical
port, set this field to
1000xfd
. Default value is
1000fd
(Electrical RJ45, 1000
Full-Duplex).
Ethernet Actual Type
– Displays the port’s actual speed/duplex (after
negotiation).
Note:
Auto-negotiation and Ethernet Speed/Duplex (in case Auto-neg disabled) must be
identical on the ODU port and the end-equipment port.
Loopback Mode
– Interface screen only. Options are: Disabled, Internal,
Internal-mac-scap, External, External-mac-swap.
Loopback Timeout
– Interface screen only. The loopback timeout (in
seconds).
Alarm Propagation
– Interface screen only. Used to define system behavior
in case of Eth or Radio link failure (port shutdown):
o
“Backward” – Eth port down in case radio link down or Eth port
down at the remote.
o
“Forward”= notification is sent to the remotein case Eth port link
down.
o
“Both Directions”= Eth port down in case of both radio or Eth link
down.
When you are finished, click
Apply
.
3.9
Configuring SNMP Settings
You can configure the SNMP V2 managers trap destination in the SNMP section of the
System screen.
Refer to Managing SNMP on page 140 for SNMP V3 attributes.
