Installation and User Manual
EtherHaul
1200™
EH-INST-02, Issue 4.0
Page 85
7.1.3.2
Shaper
Shaper is used to control traffic flows in order to optimize or guarantee performance
and improve latency by limiting the maximum bandwidth of certain flows to maintain
fairness and to assure SLA.
You must set the Committed Information Rate to a value between 1-1000 Mbps.
Table
7-2
provides an example of Shaper.
Table
7-2 Shaper Example
Radio Rate
320
Mbps
# Queue
CIR
Expected Rate
Stream rate =
60
SP CoS 7
NA
60
Stream rate =
60
SP CoS 6
NA
60
Stream rate =
60
CIR CoS 5
50
50
Stream rate =
45
CIR CoS 4
40
40
Stream rate =
15
CIR CoS 3
10
10
Stream rate =
20
CIR CoS 2
20
20
Stream rate =
40
CIR CoS 1
30
30
Stream rate =
70
BE CoS 0
0
50
Total =
370
320
The following is an example of Shaper (Strict Priority) configuration.
# scheduler configuring
set scheduler mode priority-shaper
# egress-qos configuring
set egress-qos eth0 1 color-drop blind weight 1 cir 10
set egress-qos eth0 2 color-drop blind weight 2 cir 20
set egress-qos eth0 3 color-drop blind weight 4 cir 30
set egress-qos eth0 4 color-drop blind weight 6 cir 40
set egress-qos eth0 5 color-drop blind weight 8 cir 50
Refer to
Figure 7-6 WFQ/Shaper Setup
for configuration using the Web EMS.
7.1.3.3
Egress Queues
There are eight egress queues, one queue per CoS. Eight queues on the interfaces (Eth0,
Eth1, and Eth2) are served by four queues on the radio (RF).
WFQ and Shaper can only be configured for queues 1 through 5.
